Specification

Specification Model
 Horizontal type ARH30C  Vertical type
 ARV50C  ARV100C
Maximum coil weight (kg)  30  50  100
Maximum coil width (mm)  100  100  150
Maximum outside diameter of coil (mm)  Φ650  Φ800 (stock reel K: Φ1200) *1
Inside diameter of coil (mm)  Φ155~508  Φ185~508
Motor  100W gearmotor  200W gearmotor
Main spindle revolutions  2~20 *2
Work detection method  3 types - type for conductor, general photoelectric type and high-sensitivity photoelectric type *3
 Input power  Single-phase AC100V ±10%, 50/60Hz
 Three-phase AC200V ±10%, 50/60Hz
 Power consumption(VA)  150  300
Operating temperature(℃)

 0~40

Storage temperature (℃)  −10~60
Humidity (%)  0~90
Atmosphere  No corrosive gas or dust, etc.
Weight (kg)  43[13]  52[13]  73[13]

The figure in [ ] is the weight of the controller.


*1: Stock reel K: φ1200 is dedicated part of ARV100C.
*2: It is possible to use under the limited condition in case of used outside the specified range.
*3: In case of photoelectric detection method, detectable material is the opaque which is wider than 5mm for general type,
and is wider than 1mm for high-sensitivity type due to sensor characteristics.
(However, a part of detection area is required to be wider than 5mm or 1mm in the case of grid-like punching process.)
Please choose after making sure that material meets this condition.
Work may not be detected in the case of material which is performed punching process (blank).