Main Menu
Sub Menu
Contents

In-Cavity resin pressure measuring system

  • The new pressure measurement amplifier(model MPS08)meets the CE certification
  • Sensor’s pin can replace existing ejector pin due to its same shape as ejector pin.
  • Pin can be cut to fit the size of mold.

*1: Combined use with a pressure measuring amplifier MPS08 is required.

Specification

Pressure Measurement Amplifier Set MPS08S

Specification SSE series
Rated capacity Tip diameter Φ0.8 Φ1.0 Φ1.2 Φ1.5 Φ2.0 Φ2.5 Φ3.0
Unit: N 50.3 78.5 113.1 176.7 314.2 490.9 706.9
Rated pressure 100MPa
Measurement range 0∼100MPa
Ejector pin travel At Rated pressure
Unit:mm
0.050 0.040 0.040 0.055 0.073 0.080 0.076
Allowable pressure 100MPa
Pin material SKH51 *1(hardness: 58~60HRC)
Pressure element Strain guage
Non-linearity ±2.0%F.S.
Operating temperature range Up to 150°C
Sensitivity variation 0.05%F.S./°C max

*1 The material for SSEEJ-3.0x400is SKD61.The hardness of SKD61 is over 900HV (nitrided after thermal refining)

External Dimension

External Dimension