Main Menu
Sub Menu
Contents

In-Cavity resin pressure measuring system

  • Since this product is placed directly under an ejector pin for measurement, you can utilize your existing ejector pin.
  • This product is compatible with various pins such as a small-diameter pin, square pin, rare-shaped tip pin, and flange-cut pin that are not compatible with conventional ejector pin—type sensors.

*1: Combined use with a pressure measuring amplifier MPS08 is required.

Specification

Product name SSB050ZN08x06 SSB200ZN08x06 SSB01KN08X06
Rated capacity 50N(5.1kgf) 200N(20.4kgf) 1000N(102.0kgf)
Stroke amount *2 0.02mm(for 50N) 0.02mm(for 200N) 0.02mm(for 1000N)
Body material SUS630(hardness: 38HRC or less)
Pressure detection element Strain guage(attached on the inner surface of the projection side)
Non-linerarity ±2.0%F.S.
Operating temperature range 150°C or less
Sensitivity change 0.05% F.S./°C max

*1: Combined use with a pressure measuring amplifier MPS08 is required.
*2: This represents the deflection amount of the projection side when a pressure is detected.

External Dimension

External Dimension

*3:Load applying direction: The arrow in the drawing shows the positive direction of the load.
*4:This represents the deflection amount of the projection side when a pressure is detected.